20
RQT9785
To prevent the speakers from falling, it is recommended, as an additional protection
measure, to attach the speakers to the wall or table with a fall prevention cord (hereafter
“cord”).
≥ Consultation with a qualified installation specialist concerning the appropriate procedure when attaching to a concrete wall or
a surface that may not have strong enough support is recommended (> 12, 15). Improper attachment may result in damage
to the wall and speakers, and personal injury.
≥ Use a cord that is capable of supporting over 10 kg (with a diameter of about 1.5 mm).
≥
The speaker fall prevention measure is to minimize the possibility of damage and harm, but it does not completely guarantee this effect.
≥ Keep the screws out of reach of children to prevent swallowing.
≥ Make sure that the slack of the cord is minimal.
≥ Depending on the placement of the speakers, the screwing position of the screw eye may differ.
Additional speaker fall prevention measures
When attaching the speakers horizontally
A Cord* B Screw eye C Wall
* If the cord cannot be threaded through the holes, try bending the cord in 2 locations, about
10 mm apart from the tip, at an angle of 45
o
(as
illustrated above).
C
A
C
B
A
SC-HTB570_RQT9785-B_mst.book 20 ページ ２０１３年１月１０日 木曜日 午後２時５６分
To Next Page
Loading...
