Panasonic SC-HTB570

32
RQT9785
The main unit is automatically switched to
standby mode.
The auto standby function is on.
The main unit will automatically switch to standby
mode when no signal is input and no operation is
performed for approx. 2 hours. Refer to page 30
to turn this function off.
The main unit is turned off when the TV’s
speakers are selected in the speaker control.
This is a normal feature when using VIERA Link
(HDAVI Control 4 or later). Please read the
operating instructions for the TV for details about
its power save feature. (> 28)
This system does not operate correctly.
If the HDMI cable is connected to the wrong
terminal (HDMI IN or HDMI OUT), this system will
not operate correctly. Turn the main unit off,
disconnect the AC mains lead and reconnect the
HDMI cable(s). (> 22, 23)
VIERA Link related operations no longer
function properly.
≥ Check the VIERA Link setting on the connected
devices.
≥ Have you turned the VIERA Link settings off?
(> 31)
≥ When the HDMI connections are changed,
after a power failure or after the AC mains lead
has been removed, VIERA Link operations may
not function properly.
jTurn on all the devices that are connected to
the TV with an HDMI cable and then turn the
TV on.
jTurn off the VIERA Link settings of the TV
and turn it on again. For details refer to the
operating instructions for the TV.
jWhile the main unit and the TV are
connected with the HDMI cable, turn on the
TV and then remove the main unit’s AC
mains lead and reconnect it again.
The first few seconds of audio cannot be
heard when using the HDMI connection.
This may occur during DVD-Video chapter
playback. Change the digital audio output setting
on the connected device from “Bitstream” to
“PCM”.
When operating an HDMI compatible device
of a different brand, the main unit reacts in an
unwanted manner.
HDAVI Control commands may use a different
signal depending on the brand of the device. In
this case, turn VIERA Link off. (> 31)
Pairing cannot be done.
Check the Bluetooth
®
device condition.
The device cannot be connected.
≥ The pairing of the device was unsuccessful or
the registration has been replaced. Try pairing
the device again. (> 25)
≥ This system might be connected to a different
device. Disconnect the other device and try
pairing the device again.
The device is connected but audio cannot be
heard through this system.
For some built-in Bluetooth
®
devices, you have to
set the audio output to “SC-HTB570” manually.
Read the operating instructions for the device for
details.
The sound is interrupted.
≥ The device is out of the 10 m communication
range. Bring the Bluetooth
®
device closer to the
main unit.
≥ Remove any obstacle between the main unit
and the device.
≥ Other devices that use the 2.4 GHz frequency
band (wireless router, microwaves, cordless
phones, etc.) are interfering. Bring the
Bluetooth
®
device closer to the main unit and
distance it from the other devices.
≥ Select “MODE1” for stable communication.
(> 29)
No sound (or image).
≥ Turn muting off. (> 26)
≥ Check the connections to the other devices.
(> 22, 23)
≥ Make sure that the received audio signal is
compatible with this system. (> 35)
≥ Turn this system off and then on again.
≥ If the main unit is connected to the TV with only
an HDMI cable, make sure that the TV’s HDMI
HDMI
Bluetooth
®
Sound
SC-HTB570_RQT9785-B_mst.book 32 ページ ２０１３年１月１０日 木曜日 午後２時５６分