Panasonic SC-HTE200

Getting started
Operations
SQT0858
15
Operations
Using this system
Preparation
≥ Turn on the TV and/or connected device.
1Press [Í] to turn on the main
unit.
2 Select the source.
≥ This remote control cannot be used to control the
operations of the connected devices.
∫ When you select “BD/DVD”
Change the input on the TV to the one this unit
is connected to, then start play on the device
connected to this unit.
∫ When you select “AUX”
Start play on the device connected to the audio
input terminal on this unit.(> 10, “Connection
from an other device (AUX)”)
∫ When you select “BLUETOOTH”
Start play on the Bluetooth
®
device connected to
this unit.
∫ To adjust the volume of this system
Press [j VOL i].
≥ Volume range: 0 to 100
∫ To mute the sound
Press [MUTE].
≥ While muting, “MUTE” is indicated on the display.
≥ To cancel, press the button again or adjust the volume.
≥ Muting is cancelled if the main unit is turned off.

≥ If there is sound coming out of the TV’s speakers, reduce
the volume of the TV to its minimum.
≥ There may be a difference in the maximum volume value
of the TV and the unit.
≥ When playing equipment connected to the HDMI AV IN
terminal, to switch audio/video to the TV, switch input to
the TV tuner. If VIERA Link (HDMI) (> 19) is not
enabled, also switch the input of this unit to TV.
Press To select
[INPUT]
Input changes in the
following order each time
you press [INPUT].
“TV”# “BD/DVD”# “AUX”
^----“BLUETOOTH”(-}
≥ When switching the source to
“BLUETOOTH” and then to
“TV” in succession, after
switching it to “BLUETOOTH”,
wait for a while, and press
[INPUT].
[ -PAIRING]
Select the Bluetooth
®
device as the source.
(> 13, 14)
SOUND
INPUT
SETUP


OK
1
2
If this system does not operate as
expected or sound is unusual, returning
the settings to the factory preset may
solve the problem. (> 20)
SC-HTE200-SQTxxxx.book 15 ページ ２０１５年４月２７日 月曜日 午前１０時２分