Panasonic SC-HTE200

18
SQT0858
Setup menu
1 Press [SETUP] repeatedly to
select the setup item.
2Press [4][3] repeatedly to
select the desired setting and
then press [OK].

≥ The default setting is underlined. Changed settings will
be kept until it is changed again, unless otherwise
indicated.
DIMMER
Dims the display after
5 seconds of inactivity.
ON
OFF
BEEP
A beep sounds when you
touch the switch on the main
unit or when you turn the unit
on/off.
≥ This works during muting as
well.
ON
OFF
AUTO POWER
DOWN
The main unit automatically is
turned off if there is no audio
input and when you do not
use it for approx. 20 minutes.
ON
OFF
≥ When this is set, the display
shows “P.OFF 1” to indicate
that the main unit will turn
off in approximately 1
minute.
VOL
LIMITATION
Sets the volume limit to 50
when you turn on the main
unit although the volume is
set to above 50 before it is
turned off.
ON
OFF
BLUETOOTH
STANDBY
This function allows you to
connect a paired Bluetooth
®
device when the main unit is
in standby mode.
ON
OFF
The main unit will be turned
on automatically when you
connect a paired Bluetooth
®
device.
≥ If this function is set to
“ON”, the standby power
consumption will increase.
LINK MODE
Change the transmission
mode to prioritise
transmission quality or sound
quality. Make sure that the
Bluetooth
®
device is not
connected (“BLUETOOTH
READY” is indicated on the
display).
MODE 1: Emphasis on
connectivity.
MODE 2
: Emphasis on sound
quality.
VIERA LINK
Turn on the VIERA Link
function.
ON
OFF
Select “OFF” when your
HDAVI Control device does
not work correctly with this
system.
≥ ARC will be disabled.
Connect an optical digital
audio cable.
≥ Turn off all connected
devices and then turn them
on again after changing the
setting.
SC-HTE200-SQTxxxx.book 18 ページ ２０１５年４月２７日 月曜日 午前１０時２分