ENGLISH
RQTX0190
18
iPod
iPod does not turn on. Verify that the iPod battery is not depleted before connecting it to the unit.
Before inserting your iPod into the dock, turn off both the unit and iPod. Power on
the unit and select the appropriate source.
•
•
No sound is coming from
the speakers.
The iPod is not correctly inserted into the dock. Turn off the iPod, remove it from
the dock connector. Reinsert it and turn it on again.
Make sure that iPod is actually playing something.
Adjust the volume.
•
•
•
Music is distorted or the
sound level is too low.
Make sure the equaliser function of your iPod is turned off.•
Cannot control the iPod
from the CD Stereo
System.
Make sure the iPod is inserted properly into the dock.
Check the dock connection and make sure that iPod is selected as the source of
music. (➡ page 15)
•
•
iPod does not charge.
Check all connections. (➡ page 15)•
USB
The USB drive or its
contents cannot be read.
The USB drive format or its contents is/are not compatible with the system
(➡ page 16). The USB host function of this product may not work with some USB
devices.
USB devices with storage capacity of more than 8 gigabytes may not work in some
instances.
•
•
Slow operation of the
USB flash drive.
Large file size or high memory USB flash drive takes longer time to read.•
“NO PLAY” Check the content.
Only MP3 format files can be played.
•
•
DAB
DAB reception is poor
Keep the antenna away from computers, televisions, other cables and cords.
Use an outdoor antennas. (➡ page 5)
•
•
DATA
Data broadcast being received over the DAB broadcast signal. Cannot be used on
this unit.
•
SCRAMBLED The broadcast station being received cannot be accessed.•
NO SERVICE The station is currently not broadcasting.•
NO SIGNAL
This station cannot be received. Check your antenna. (➡ page 4)•
SCAN FAILED
Stations are not receivable. Check your antenna and try Auto scanning.
(➡ page 4, 10)
•
STATION FULL
DAB station memory is full. Use the following method to clear station memory.
Press [DAB MENU].
Press [e,r] to select “STATION CLEAR”.
Press [OK]. “OK? Push OK” is displayed.
Press [OK].
Station memory is erased and the unit automatically begins Auto scanning.
•
1.
2.
3.
4.
Troubleshooting guide (continued)
SC-PM42DBEB.indb 18 1/6/2010 10:14:59 AM
To Next Page
Loading...
Need help?
General
