ENGLISH
RQTX0190
13
This is a 24-hour clock.
1 Press [CLOCK/TIMER] to select “CLOCK”.
Each time you press the button:
You can set the timer to come on at a certain time to
wake you up.
Preparation
Turn the unit on and set the clock.
Prepare the music source (disc, radio, USB or iPod
source) and set the volume.
•
•
This function enables you to turn off the unit
automatically after the set time.
Press [SLEEP] repeatedly to select your desired
time.
Setting the clock
2 Within 5 seconds, press [u/t] or [y/i] to
set the time.
3 Press [CLOCK/TIMER] again to confirm.
Displaying the clock
Press [CLOCK/TIMER] to display the clock for a few
seconds.
The clock may lose or gain minutes over a period of
time. Readjust as necessary.
1 Press [CLOCK/TIMER] repeatedly to select play
timer.
2 Within 5 seconds, press [u/t] or [y/i] to
set the starting time.
3 Press [CLOCK/TIMER] to confirm.
4 Repeat steps 2 and 3 to set the finishing time.
To activate the timer
5
Press [z, PLAY] turn on play timer.
Note
To cancel
Press [SLEEP] to select “OFF”.
Changing the remaining time
Press [SLEEP] to show the remaining time, and press
[SLEEP] again to select your desired time.
The play and sleep timer can be used together. The
sleep timer always has priority. Be sure not to overlap
timer settings.
Note
6 Press [^] to turn off the unit.
To Action
change the
settings
Repeat steps 1 to 4 and 6.
change the
source or
volume
Press [z, PLAY] to clear the timer
indicator from the display.
Make changes to the source or
volume.
Perform steps 5 and 6.
1)
2)
3)
check the
settings (when
the unit is on
or in standby
mode)
Press [CLOCK/TIMER] repeatedly to
select zPLAY.
cancel
Press [z, PLAY] to clear the timer
indicators from the display.
Using the sleep timer
Sleep timer indicator
Using the play timer
CLOCK
zPLAY
Original display
CLOCK
zPLAY
Original display
Play
timer indicator
Start time
Finish time
zPLAY
No display (off)
The play timer will start at the preset time, with the
volume increasing gradually to the preset level.
The timer comes on at the set time every day if the
timer is on.
The unit must be in the standby mode for the timer to
function.
If you turn the unit off and on again while a timer is
functioning, the finish time setting will not be activated.
•
•
•
•
Note
Using the timer
SC-PM42DBEB.indb 13 1/6/2010 10:14:46 AM
To Next Page
Loading...
Need help?
General
