6.2.3. BAKE mode confirmation test
1. Form the Initial test mode (6.1.1), press the "SELECT" pad once.
2. The LCD indication shown in BAKE mode confirmation test LCD
will appear, and the operation LED (Red) will lightup.
3. The heater will be heated at relay current flow ratio of 32/32 (100
percent). When the 329°F (165°C), the display will return to the
initial test mode, after about 7 minutes.
4. To return to Initial test mode (6.1.1), press "Start/Stop" pad once.
BAKE mode confirmation test LCD
7. BAKING PROGRAMS
Note:
- The duration of each process is only approximate and will vary
according to the ambient temperature.
- The following time is when the timer is not used. (The availability to
choose the timer is indicated with a circle (O) in the “Timer”
column.)
- There will be keep-warm of up to 60 minutes after the baking is
complete until the STOP pad is pressed, for all BAKE options. The
28
To Next Page
Loading...
