Parts Changes
SD-YD250
YD-205/YD20 or YD200
1. Belt 5 ribs / Width: 8.0 mm 4 ribs / Width: 6.4 mm
2. Pulley B Width of ditch for belt: 9.6
mm
Width of ditch for belt: 8.0
mm
3. Pulley A / (This part has
been press-fit to the motor
axis.)
5 ribs 4 ribs
Remarks
1. Parts for SD-YD250 shown in the table are not interchangeable
with those parts of earlier models.
2. Parts shown in table are not interchangeable with earlier models.
However, if all three parts (Belt, Pulley and Kneading motor) are
exchanged together, those parts can be used with the SD-YD205/
Y020, YD200.
37
To Previous Page
Loading...
