No. Parts Name
1 Temp. sensor (Between tab (A); approx. 27k :
25°C)
2 Temp. fuse (Between (B)-(C); 0 )
3 Heater (Between (D)-(E); approx. 25
4 Angle
5 Heater Case Ass’y
6 P.C. Board B Ass’y
7 Motor / White-Red:approx. 30 / White-Blue:
approx. 29
2. DISASSEMBLY PROCEDURE
Note:
The assembly procedure is the reverse of the disassembly procedure
2.1. Removal of PCB (A) and Solenoid
1. Remove the two screws on the front rear corner which secures
the control panel. (Fig.1)
Fig.1
5
To Next Page
Loading...
