40
VQT3E42
This unit will resume recording pause mode
about 0.8 seconds after the LCD monitor is
reopened.
¬ Change the mode to .
1 Select the menu. (l 27)
2 Close the LCD monitor while
the mode is set to .
The status indicator A flashes green and the
unit goes into Quick start standby mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit
is put into recording pause.
≥ When in Quick start standby mode
about 70% of the power used in
Recording pause mode is being
consumed, so the recording time will
be reduced.
≥ Quick start standby mode is canceled if
jabout 5 minutes have elapsed
jmode is set to
≥ It may take some time for Automatic white
balance to adjust.
≥ In the Quick start mode, the zoom
magnification becomes 1k.
≥ If [ECONOMY] (l 29) is set to
[5 MINUTES] and the unit automatically
goes into Quick start standby mode, close
the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
When the power is turned on with the mode
set to , the unit will enter the recording
pause mode after about 1.9 seconds.
Select the menu. (l 27)
≥ In the Quick power on mode, the zoom
magnification becomes 1k.
Quick start
[SETUP] # [QUICK START] # [ON]
Quick power on
[SETUP] # [QUICK POWER ON] #
[ON]
SDR-H100&S71&S70&T70-VQT3E42_eng.book 40 ページ ２０１０年１１月２９日 月曜日 午後６時２１分
To Next Page
Loading...
