94
VQT3E42
With a PC
Setup
2
Connecting to a PC
≥ Connect this unit to the PC after the software applications are installed.
≥ Remove the supplied CD-ROM from your PC.
A USB cable (supplied)
1 Connect this unit to the AC
adaptor.
≥ It is possible to use the unit connected to
the PC with the batteries only, but you will
not be able to write data into the unit.
≥ Use the AC adapter to free you from
worrying about the battery running down.
2 Turn on the unit.
≥ This function is available in all modes.
≥ When using the battery, the LCD monitor
will be turned off after about 5 seconds.
Operating the joystick will cause the LCD
monitor to turn on again.
3 Connect this unit to a PC.
≥ Insert the USB connectors as far as they
will go.
≥ Do not use any other USB cables except
the supplied one. (Operation is not
guaranteed with any other USB cables.)
≥ The Smart wizard screen is automatically
displayed when VideoCam Suite 3.5 is
installed.
≥ This unit is automatically recognized as an
external drive of the PC. (l 97)
≥ A USB function selection screen will be
displayed if VideoCam Suite 3.5 has not
been installed. Use the joystick to select
[PC], then press the center of the
joystick.When you select an option other
than [PC], reconnect the USB cable.
≥ When Windows is used as the PC
operating system, a message prompting
to format may display when a SDXC card
is read. (Please be aware that if a media is
formatted, then all the data recorded on
the media will be erased.)
http://panasonic.net/avc/sdcard/
information/SDXC.html
SDR-H100&S71&S70&T70-VQT3E42_eng.book 94 ページ ２０１０年１１月２９日 月曜日 午後６時２１分
To Next Page
Loading...
