Panasonic SF2H Series

53
English
[Extended standby mode]
Sets the operation in standby mode by the “Power
management” function for the input terminal for which
the “Power management” function is set to [On].
[On]:
If a video signal (synchronized signal) is detected
at any of the input terminals for which the “Power
management” function is set to [On], the power
is turned “ON”, and the input is switched to the
detected input.
[Off]:
If a video signal (synchronized signal) is detected
at the input terminal with which the standby mode
is entered, the power is turned “ON” with the input.
Note
●
If [Input search] is set to items other than [Off], the
[Input search] function is prioritised. (The “Power
management” function does not operate for each
terminal.) (For details of [Input search] function, see
page 69.)
●
When [Failover/Failback] - [Input change mode] is
set to items other than [Off], the [Failover/Failback]
function is prioritised. (The “Power management”
function does not operate for each terminal.) (For
details of [Failover/Failback] function, see page 70.)
HDMI-CEC settings
Set for HDMI-CEC function.
For details of HDMI-CEC function, refer to “Using HDMI-
CEC function”. (see page 112)
[HDMI-CEC settings] - submenu screen
1
HDMI-CEC settings
HDMI-CEC control Enable
Disable
HDMI2
----
----
HDMI-CEC operation
MENU code
HDMI1
Display→Device
Disable
Device→Display
Link function
■ [HDMI-CEC control]
Enables/Disables the HDMI-CEC function.
[Disable]: Disables HDMI-CEC control.
[Enable]: Enables HDMI-CEC control.
Note
●
Set to [Enable] to operate HDMI-CEC compatible
device with remote control of the unit.
■ [HDMI1]
Displays the device to operate when HDMI-CEC
compatible device is connected to HDMI 1 terminal.
The control subject can be changed with
.
Note
●
When there is no connected device, [----] will be
displayed.
■ [HDMI2]
Displays the device to operate when HDMI-CEC
compatible device is connected to HDMI 2 terminal.
The control subject can be changed with
.
Note
●
When there is no connected device, [----] will be
displayed.
■ [HDMI-CEC operation]
Displays the operation screen of the HDMI-CEC
compatible device.
Press <RETURN> to hide the operation screen.
■ [MENU code]
Changes the code to assign for the [MENU] operation
on the HDMI-CEC operation screen.
Adjust the code to that of the connected HDMI-CEC
compatible device.