Panasonic SF2H Series - Page 73

73
English
Onscreen display
Set to display / hide the following Onscreen display.
●
Power on display
●
Input signal switch display
●
No signal display
●
No external media display (at USB input)
●
MUTE display after displaying the menu screen
●
Off timer remaining time display when 3 minutes
remaining
●
Display when responding to commands from external
control
[On]:
Displays the Onscreen display.
[Off]:
Hides the Onscreen display.
Initial input
Adjusts the input signal when the unit is turned on.
[Off] / [HDMI1] / [HDMI2] / [DIGITAL LINK] /
[DVI-D] / [PC] / [VIDEO] / [USB] / [MEMORY
VIEWER]
Note
This menu is available only when [Input lock] is [Off].
(see page 73)
Initial VOL function
Enables/Disables [Initial VOL function] when the unit is
turned on.
[Off]:
It will be the sound volume level which had been
set before the power of the unit was turned off.
[On]:
It will be the sound volume level set for [Initial VOL
level].
Initial VOL level
Sets the sound volume when [Initial VOL function] is
enabled.
Note
●
Outputs with the set volume when [Initial VOL
function] is [On].
●
When [Maximum VOL function] is [On], the volume
cannot be set to the level higher than the level set for
[Maximum VOL level].
Maximum VOL function
Enables/Disables [Maximum VOL function].
[Off]:
The sound volume level can be set up to 100
(maximum).
[On]:
The volume cannot be set to the level higher than
the level set for [Maximum VOL level].
Maximum VOL level
Sets the sound volume when [Maximum VOL function]
is enabled.
Note
●
Outputs with the set volume when [Maximum VOL
level] in [On] state is selected on the menu.
●
When the [Maximum VOL function] is switched from
[Off] to [On], if the [Maximum VOL level] is set lower
than the [Initial VOL level], the [Initial VOL level]
automatically becomes the same as the [Maximum
VOL level].
Input lock
Disables [Input] operation by locking the input.
[Off] / [HDMI1] / [HDMI2] / [DIGITAL LINK] / [DVI-D]
/ [PC] / [VIDEO] / [USB] / [MEMORY VIEWER]
Note
●
Input switch can be used when this is set to [Off].