Panasonic SF4B Series

24© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Function Setting
<Inputting a password>
When the protective function is effective, “Lock” is shown on the lower section of the digital display.
The functional settings of the SF4B / SF4B<V2> series cannot be changed unless the password is
input.
Note that “3-3-9 Protective Function” is “locked” even when the protective function is ineffective.
Remarks
1) “3-3-11 Setting Contents Monitoring Function” is not “locked.”
2) Once the password is input, you do not need to input the password again till the power is
turned OFF. (Except “3-3-9 Protective Function”) However, if the power is turned ON again
without changing the protective function to ineffective, the password have to be input again
since the protective function is still effective.
The procedure for inputting a password is as follows.
Ɣ When using with SF4B / SF4B<V2> series only
key operation
: ENTER
: CANCEL
: -
: +
SF-C14EX
Input password
Complete inputting password
NG
Input password
CH1
CH2
CH3
Complete inputting password
NG
NG
NG
Complete inputting password for 1 unit
Complete inputting password for 2 units
Ɣ When using in combination with SF-C14EX
Ramco Innovations
(
800
)
280-6933 www.PanasonicSensors.com