RQTX0051
5
Setup
ENGLISH
Refer also to the operating instructions for your home theater unit.
STEP 1:
On the wireless sound system:
STEP 2:
On the home theater unit:
Turn the unit on and check the wireless link indicator.
≥ The WIRELESS LINK indicator on the wireless sound system also lights up when
the wireless link is active.
Conserving power
The wireless sound system consumes a small amount of power, even when it is in off
mode (approx. 0.2 W). To save power when the unit is not to be used for a long time,
unplug it from the household AC outlet.
Making the wireless link
POWER
WIRELESS LINK
OPTION POWER
WIRELESS
OPTION
MUSIC PORT
SELECTOR
VOL
MIN MAX
WIRELESS CONTROL
TUNE
2 Turn the unit on.
1 Reduce the volume
to “MIN” position.
3 Press [SELECTOR] repeatedly to select “WIRELESS”.
“WIRELESS” indicator lights up.
WIRELESS LINK
indicator
SLP
ST CT
RDS
RND
PGM
EQ
PRG
SRDE.
PL
DDTS
WS
W1
W2
e.g. Display on the home theater unit
“ [W2] ”or an indicator should light up.
≥ If “ [W2] ”or an indicator is flashing,
refer to page 11, Troubleshooting guide.
∫ Pairing with your existing Panasonic wireless
accessories
§
of the home theater system
Pairing is needed for using your SH-FX85 together with your existing Panasonic
wireless accessories (not included) on the same home theater system.
Preparation
≥
Use the SH-FX85T transmitter card for pairing.
Unplug its SB-FX85 wireless
sound system from the AC outlet.
Store your SH-FX65T transmitter card in a cool dry place for later use.
≥Make sure to connect the AC power supply cords of your wireless accessories.
≥Turn on the home theater unit and reduce the volume.
1 Turn on the wireless accessories you want to use together with SH-FX85.
2 While pressing [5/9] on the home theater unit,
press the numbered button [3] on the remote control until “P” lights in the home
theater unit’s display.
3 While “P” is displayed, press [I/D SET] on each of your wireless accessories.
≥If “P” goes off before you press [I/D SET] of your next wireless accessory,
repeat step 2 and then continue the procedure.
4 While pressing [5/9] on the home theater unit,
press the numbered button [3] on the remote control.
≥
The corresponding wireless link indicator (
“ [W1] ”, “ [W2] ”, or “ [WS] ”)
lights on
the home theater unit.
5 Turn off and on your wireless accessories.
≥Make sure the wireless link indicators on your wireless accessories light up.
[Note[
Repeat the above steps if you should use SH-FX65T transmitter card.
(The link with SH-FX85 will be disconnected.)
Use a pointed object.
e.g.
RQTX_FX85_En.fm Page 5 Thursday, December 21, 2006 2:56 PM
To Next Page
Loading...
