Panasonic TC-P58S2

25
8.13. Remove the Support metal
1. Remove the screws (×6 ).
2. Remove the Support metal.
8.14. Remove the Hanger metals and
the Stand brackets
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Remove the Support metal. (See section 8.13.)
3. Remove the Hanger metals (L, R) fastening screws (×6
each) and remove the Hanger metals (L, R).
4. Remove the Stand brackets (L, R) fastening screws (×4
each) and remove the Stand brackets (L, R) and the
Bracket covers (L, R).
8.15. Remove the C1-Board
1. Remove the Hanger metal R and Stand bracket R. (See
section 8.14.)
2. Remove the flexible cable holder fastening screws (×10
).
3. Disconnect the flexible cables (CB1, CB2, CB3, CB4 and
CB5).
4. Disconnect the flexible cable (C10).
5. Remove the screws (×5 ) and remove the C1-Board.
8.16. Remove the C2-Board
1. Remove the Support metal. (See section 8.13.)
2. Remove the flexible cable holder fastening screws (×10
).
3. Disconnect the flexible cables (CB6, CB7, CB8, CB9 and
CB10).
4. Disconnect the flexible cables (C20, C21 and C26).
5. Remove the screws (×5 ) and remove the C2-Board.
8.17. Remove the C3-Board
1. Remove the Hanger metal L and the Stand bracket L.
(See section 8.14.)
2. Remove the flexible cable holder fastening screws (×10
).
3. Disconnect the flexible cables (CB11, CB12, CB13, CB14
and CB15).
4. Disconnect the flexible cables (C31, C33 and C36).
5. Disconnect the connector (C35).
6. Remove the screws (×6 ) and remove the C3-Board.