22
8.11. Remove the SD-Board
1. Remove the Control button unit. (See section 8.8.)
2. Remove the flexible cables (SD1, SD2, SD3, SD4 and
SD5) connected to the SD-Board.
3. Remove the flexible cable (SU11-SD11) and the bridge
connectors (SC42-SD42 and SC46-SD46).
4. Remove the molding props (×3 ).
5. Remove the screws (×3 , ×3 ) and remove the SD-
Board.
8.12. Remove the SC-Board
1. Remove the SU-Board and SD-Board. (See section 8.10.
and 8.11.)
2. Unlock the cable clampers to free the cable.
3. Disconnect the connector (SC2).
4. Disconnect the flexible cable (SC20).
5. Remove the screws (×9 ) and remove the SC-Board.
8.13. Remove the SS2-Board
1. Disconnect the bridge connector (SS02-SS24A) and dis-
connect the flexible cable (SS52).
2. Remove the screws (×2 ) and remove the SS2-Board.
To Next Page
Loading...
