24
8.18. Remove the Vertical bar-down
assy
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Remove the Support metal (C). (See section 8.16.)
3. Remove the screws (×2 , ×2 each) and remove the
Vertical bar-down assy (L, R).
4. Remove the screws (×4 each) and remove the V-bar
connecting metal-top (L, R).
5. Remove the screws (×2 ) and remove the V-bar fixing
metals (L, R).
6. Remove the screws (×2 each) and remove V-bar con-
necting metal-bottom (L, R) and the Bracket covers (L,
R).
8.19. Remove the C1-Board
1. Remove the Control button unit. (See section 8.8.)
2. Remove the Support metal (C). (See section 8.16.)
3. Remove the Support metal (R). (See section 8.17.)
4. Remove the Vertical bar-down assy. (See section 8.18.)
5. Remove the flexible cables holder fastening screws (×10
).
6. Disconnect the flexible cables (CB1, CB2, CB3, CB4 and
CB5).
7. Disconnect the flexible cable (C10).
8. Disconnect the connector (C14).
9. Remove the screws (×5 ) and remove the C1-Board.
8.20. Remove the C2-Board
1. Remove the Support metal (C). (See section 8.16.)
2. Remove the flexible cables holder fastening screws (×10
).
3. Disconnect the flexible cables (CB6, CB7, CB8, CB9 and
CB10).
4. Disconnect the flexible cables (C20, C21 and C26).
5. Remove the screws (×5 ) and remove the C2-Board.
To Next Page
Loading...
