Panasonic Technics SL-1800

How to play
Adjustments
@Set the switch lever to “ON” position. (See Fig. 15)
@Set the speed selector to the desired record speed. (See Fig. 16)
Speed selector
a3} as
90:
180 the arm clamp, (Refer to Fig. 9)
OLit the cueing lever as indicated by the arrow. (See Fig. 17)
Cueing tever
@
Move
the
tonearm
over
the
record
and
then
lower
the
cueing
lever.
The tonearm
will descend
slowly
onto the record
and
play will begin.
the cusing lever and
cure it with the arm clamp.
@Get the switch lever to “OFF” position
(The turntable platter will rotate for a short time due to its
inertia
It you play a 45 r.p.m. record with a large centre hole. use
the furnished adaptor on the centre spindle
@Adjustment
of
the
arm
lift
height.(See
Figs.
18
and19),
The
arm
lft
height
(distance
between
the
stylus
tip
and
record
surface
when
cueing
lever
is
raised)
has
been
ad-
justed
at
the
factory
detore
shipping
to
approximately
§ to
10
mm
(3/16"
to
25/68"),
I the
clearance
becomes
too
narrow
of
too
wide
because
of
the
physical
size
of
the
different
cartridges
on
the
market,
turn
the
agjustment
screw
clockwise
or
counterclockwise,
at
the
same
time
pushing
the
arm
lift
down,
Clockwise
rotation
—distance
between
the
record
and
stylus
tip
is
reduced.
Counterclockwise
rotation
—distance
between
the
record
and
stylus
tip
increases,
Cueing ter
5 to 10 mm (9/16" to 25/64")
Note:
‘As the adjusting screw has a hexagon head, be sure to make
the adjustment while depressing the arm lit
©Speed adjustment (with pitch control knobs}(See Figs.20.21and22)
Strobe dots are set on the tapered rim of the turntable plat-
ter
according
to
the
power
frequency
and
the
number
of
‘revolutions of the records. Make adjustment, referring to
strobe dot indication. (See Fig. 20)
45pm.
53-13 rpm,