40
Options Adjustments
Item Adjustments
Function button assign 1
Function button assign 2
Set the functions that operates when is pressed.
Signal: The “Signal” menu is displayed.
Screensaver: The “Screensaver” menu is displayed.
ECO menu: The “ECO Mode settings” menu is displayed.
Note:
Factory settings are as follows.
FUNCTION1 button: Signal
FUNCTION2 button: Screensaver
Use the FUNCTION button
The menu screen is displayed. (Example: Signal)
Cinema reality
Signal
Off
HDMI Range
Noise reduction
Auto
Off
[
Digital
]
H-Freq.
Dot Clock Freq.
kHz
MHz
63.98
108.0
V-Freq. Hz
60.02
Signal Format
1280×1024/60
Press the FUNCTION button to exit from the menu.
Normalisation
When both main unit buttons and remote control are disabled due to the “Button lock”, “Remocon User level” or
“Remote ID” adjustments, set all the values “Off” so that all the buttons are enabled again.
Press the
button on main unit together with button on the remote control and hold for more than 5 seconds. The
“Shipping” menu is displayed and the lock is released when it disappears.
Input Search
Primary Input
Off
Secondary Input
Input Search
Searching...
Press ACTION ( ) button
Options
1/3
On screen display
Input Search
On
Initial input
Off
Input Search
Off: When there is no signal, the input is not switched automatically.
All Inputs: Searches all inputs and switches to an input with a signal.
Priority: Searches “Primary Input” and “Secondary Input” in order and switches to an input with a signal.
Primary Input, Secondary Input
Set the input to search when “Priority” is selected.
(NONE)
HDMI DVI PC
Notes:
• This menu is available only when “Input lock” is “Off”. (see page 39)
“Searching...” is displayed during the input search.
1
select
2
adjust
Input Search
When a signal is not detected, another input with a signal is automatically selected.
To Next Page
Loading...
