English
8
or PVC.
Usage of a chemical cloth
•
Do not use a chemical cloth for the panel surface.
•
Follow the instructions for the chemical cloth to use it
for the cabinet.
Wired LAN
When setting up the Display at a place, where
electric statistic occurs often, take a sufficient anti-
static measure before start using.
•
When the Display is used at a location, where
static electricity occurs often, such as on a carpet,
communications of the wired LAN or DIGITAL LINK
are disconnected more often. In that case, remove
static electricity and the noise source that may cause
problems with an antistatic mat, and re-connect the
wired LAN or DIGITAL LINK.
•
In rare cases, the LAN connection is disabled due
to static electricity or noise. In that case, turn off the
power of the Display and the connected devices once
and then re-turn on the power.
The Display may not work properly due to strong
radio wave from the broadcast station or the radio.
•
If there is any facility or equipment, which outputs
strong radio wave, near the installation location, set
up the Display at a location sufficiently far from the
source of the radio wave. Or, wrap the LAN cable
connected to the DIGITAL LINK / LAN terminal by
using a piece of metal foil or a metal pipe, of which is
grounded at both ends.
Disposal
When disposing the product, ask your local
authority or dealer about the correct methods of
disposal.
Accessories
Accessories Supply
Check that you have the accessories and items shown
Operating Instructions
(Book)
Operating Instructions
(CD-ROM)
Remote Control Transmitter
●
N2QAYA000099
Batteries for the Remote
Control Transmitter
(AAA/R03/UM4 type × 2)
Clamper × 3
Warranty card × 1
Power supply cord
(Approx. 2 m)
To Next Page
Loading...
