12
Basic Controls
Stand-by (ON/OFF) button
The Plasma Display must first be plugged into the wall outlet
and turnded on at the power switch. (see page 14)
Push this button to turn the Plasma Display On, from
Standby mode. Push it again to turn the Plasma Display Off
to Standby mode.
N button
(see page 21, 22, 24, 25)
PICTURE button
(see page 24)
PICTURE POS./SIZE button
(see page 20)
PC button
Push the “PC” mode selection button to select the PC mode.
This button is used to switch directly to PC mode.
TH-42PWD4
R - STANDBY
G POWER ON
INPUT
–
VOL
+
Main Power On/Off Switch
Volume Adjustment
Push the Volume Up “+” or Down “–”
button to increase or decrease the
sound volume level.
INPUT button
(AV(S Video)/Component, RGB/
PC Mode Selection)
Push the “INPUT” button to select
AV(S Video)/Component or RGB/
PC input signal modes sequentially.
(see page 15)
Power Indicator
The Power Indicator will light.
•
Power-OFF .. Indicator not illuminated
(The unit will still consume some
power as long as the power cord is
still inserted into the wall outlet.)
•
Stand-by
......Red
•
Power-ON ........Green
Status button
Push the “Status” Button to display the current system status.
1 AV(S Video)/Component, RGB/PC mode
2 Aspect mode (see page 18)
3 Off timer
The off timer indicator is displayed only when the off timer
has been set.
Off timer 90
2
3
1
AV
4:3
To Next Page
Loading...
