Panasonic TH-43LFE8W - Page 27

27
English
Selecting the input signal
Select the signals input to the unit.
Press <INPUT> or <INPUT (Unit)>.
MENU ENTERINPUT
+
-
Switches input every time the buttons are pressed.
Ɣ
Or, press <INPUT>, select the input with and
press <ENTER> to set.
PC
16:9
ĺ
HDMI1
ĺ
HDMI2
ĺ
DVI-D
ĺ
PC
ĺ
VIDEO
ĺ
USB
HDMI1: HDMI 1 terminal, HDMI input
HDMI2: HDMI 2 terminal, HDMI input
DVI-D:DVI-D IN terminal, DVI-D input
PC: PC IN terminal, PC input
VIDEO: VIDEO terminal, composite video input
USB: USB terminal, USB input
Note
Ɣ
Displays the signal name as set in [Input label]. (see
page 51)
Ɣ
Input will not be switched unless [Input lock] is set to
[Off]. (see page 60)
Ɣ
Image retention (image lag) may occur on the LCD
display panel when a still picture is kept on the panel
for an extended period. To prevent such a problem,
using the screensaver and wobbling is recommended.
(see page 50, 52)
RECALL
It is possible to check the setting status of input label,
picture mode, etc.
Press <RECALL>.
Current setting status will be displayed.
16:9
Off timer 90 min
Memory name: MEMORY2
1 Input label
2 Aspect mode (see page 29)
3 Profile name (see page 45)
4 Off timer remaining time (see page 28)
5 Clock / Mute (see page 28)
Ɣ
When there is no signal to the selected input, [No
Signal] is displayed for about 30 seconds at the end.
Ɣ
To display the clock, set [Date and time], and then
set [Clock display] to [On]. (see page 54, 63)
Unit