Remote Control Batteries
1. Pull and hold the hook, then open the battery cover.
2. Insert batteries - note correct polarity (+ and -).
AAA/R03/UM4 type
3. Replace the cover.
Helpful Hint
●
When the remote control is in frequent use, replace
the old batteries with Alkaline ones which have longer
life.
Precautions for battery use
Incorrect installation of the batteries can cause battery
leakage and corrosion that will damage the remote
control device.
Discarded batteries should be dealt with in an
environmentally-friendly manner.
Observe the following precaution:
1. Batteries must always be replaced as a pair. Always
use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon”
with “Alkaline”)
4.
Do not attempt to charge, short-circuit, disassemble,
heat or burn used batteries.
5.
Batteries should be replaced when the remote
control works sporadically or fails to operate the
Display.
6.
Do not burn or break batteries open.
7.
Do not leave batteries in direct sunlight, nor expose
them to heat from radiators, stoves, or other sources
of heat.
VESA Mounting
To mount this Display on a wall, you will need a
standard wall-mounting kit (commercially available). We
recommend using a mounting interface that complies
with the TUV-GS and/or UL1678 standard in North
America.
TH-49LFV8
TH-55LFV8
Protective Sheet
VESA Grid Tabletop standTable
Protective Sheet
VESA Grid Tabletop standTable
1. Layaprotectivesheetonaattable.Thewrapping
that was around the display in the package is good.
Place the display on the sheet, screen down, so as
not to scratch the screen face.
2. Ensure you have all the accessories for mounting
the Display (wall mount, ceiling mount, table stand,
etc).
3. Follow the instructions that come with the base
mounting kit. Failure to follow the correct mounting
procedure could result in damage to the equipment
or personal injury. The product warranty does not
cover damage caused by improper installation.
4. Use M6 mounting screws for the wall-mounting
which are at least 10mm longer than the thickness
of the mounting bracket. Make sure the screws are
tightened securely.
Protective Sheet
Protective Sheet
Tabletop stand
Tabletop stand
VESA Grid
VESA Grid
Table
Table
11
English
To Next Page
Loading...
