25
■ To remove the rechargeable battery
Completely exhaust the battery in the following procedure before disassembling.
Remote draw button
Remote erase button
Power button
While the power of the electronic pen is off, press and hold
the “remote draw button” and press the power button,
release both the buttons, and press and hold the “remote
erase button” 5 seconds.
(Keep pressing until the power button starts blinking
orange.)
Check that the power button repeats 5 times of orange
blinks.
If it does not blink orange, press and hold the power button to •
turn the power off (light off) and perform the procedure again.
Leave the electronic pen untouched while the power button
repeats blinking
When the battery is exhausted, the power button stops blinking •
and you can disassemble the electronic pen.
It may take approximately 5 hours at most to exhaust the •
battery.
Do not disassemble this product except when disposing of it.
The following ¿ gures are intended to explain
how to dispose of the product, not for describing how to repair.
The product cannot be repaired once it has been disassembled.
How to disassemble
Remove the rechargeable battery in the steps to
Cutout
Cutout
Turn and remove the pen tip cover and eraser tip cover
Remove the pen tip and eraser tip
Insert the slotted screwdriver into the cutout to open the
main body
To Next Page
Loading...
