Panasonic TH-50PF20E - Page 9

TH-50PF20E / TH-50PF20ER
4 Specifications
Power Source
Power Consumption
Power on
Stand-by condition
Power off condition
Plasma Display panel
Screen size
(No. of pixels)
Operating condition
Temperature
Humidity
Applicable signals
Color System
Scanning format
PC signals
220 - 240 V AC, 50/60Hz
445 W
Save OFF 1.1 W, Save ON 0.6 W
0.3 W
Drive method: AC type 50-inch,
16:9 aspect ratio
1,105 mm (W) x 622 mm (H) x 1,268 mm (diagonal)
2,073,600 (1,920 (W) x 1,080 (H) [5,760 x 1,080 dots]
0 °C -
20 %
40 °C
80 %
NTSC, PAL, PAL60, SECAM, Modified NTSC
525 (480) / 60i * 60p, 625 (575) / 50i • 50p, 750 (720) / 60p • 50p, 1125 (1080) /
60i • 60p • 50i • 50p • 24p • 25p * 30p * 24sF, 1250 (1080) / 50i
VGA, SVGA, XGA, SXGA
UXGA .... (compressed)
Horizontal scanning frequency 15 - 110 kHz
Vertical scanning frequency 48 - 120 Hz
Connection terminals
LAN
AV IN
VIDEO
AUDIO L-R
HDMI
COMPONENT / RGB IN
Y / G
P b /C b /B
P r /C r /R
AUDIO L-R
DVI-D IN
RJ45 10BASE-T/100BASE-TX, compatible with PJLink™
PC IN
SERIAL
BNC
RCA Pin jack x 2
TYPE A Connector
BNC
BNC
BNC
RCA PIN JACK x 2
DVI-D 24 Pin
Content Protection
AUDIO Stereo mini jack (M3) x 1
High-Density Mini D-sub 15 Pin
VBS (use HD port)
AUDIO Stereo mini jack (M3) x 1
External Control Terminal
D-sub 9 Pin
Speaker Terminal
1.0 Vp-p (75-ohm)
0.5 Vrms
with sync 1.0 Vp-p (75-ohm)
0.7 Vp-p (75-ohm)
0.7 Vp-p (75-ohm)
0.5 Vrms
Compliance with DVI Revision 1.0
Compatible with HDCP 1.1
0.5 Vrms
Y or G with sync 1.0 Vp-p (75-ohm)
Y or G without sync 0.7 Vp-p (75-ohm)
PB / CB / B:0.7 Vp-p (75-ohm)
PR / CR / R:0.7 Vp-p (75-ohm)
HD / VD:1.0 - 5.0 Vp-p (high impedance)
with picture 1.0 Vp-p (high impedance)
without picture 0.3 Vp-p (high impedance)
0.5 Vrms
RS-232C compatible
6-ohm, 16 W [8 W + 8 W] (10 % THD)EXT SP
Accessories Supplied
Remote Control Transmitter
Batteries
Clamper
Dimensions (W x H x D)
Mass (weight)
main unit only
with speakers
Note:
• Design and specifications are subject to change without notice. Mass and dimensions shown are approximate.
• This equipment complies with the EMC standards listed below.
EN55022, EN55024, EN61000-3-2, EN61000-3-3.
N2QAYB000432
R6 (UM3) Size x 2
TMME289 x 3
1,210 mm x 724 mm x 89 mm
approx. 31.0 kg net
approx. 36.0 kg
9