Panasonic TH-55CQ1 - Position; No Signal Power off; No Activity Power off

37
English
Position
Adjusts the position.
[Position] - submenu screen
Note
●
In some cases, noise appears outside the area
picture is displayed, but it is not a malfunction.
●
It is only available for PC input.
Picture SetupAudio
Move
Language
Network settings
HDMI-CEC control
EDID select
Position
No activity power off
Button lock
No signal power off
Select Return Exit
ENTER MENU EXIT
RC control lock
Picture
Auto setup
H-position
V-position
Dot clock
Clock phase
Reset
SetupAudio
Move Select Return Exit
ENTER MENU EXIT
■ [Auto setup]
Sets the operational mode of the automatic position
adjustment.
Note
●
[Auto setup] may not work when a cropped or dark
image is input. In such case, switch to a bright
image with borders and other objects are clearly
shown, and then try [Auto setup] again.
■ [H-position]
Adjusts the horizontal position of the image.
■ [V-position]
Adjusts the vertical position of the image.
■ [Dot clock]
Periodic striped pattern interference (noise) may
occur when a striped pattern is displayed. If this
happens, adjust so that any such noise is minimized.
■ [Clock phase]
Adjusts sampling clock for applicable video.
Useful when small characters appear with low
contrast and/or there are flickers at corners.
When using the adjustment pattern, make
adjustments so that no horizontal stripe noise
appears in it.
●
It should be made only after [Dot clock] has been
correctly set.
■ [Reset]
Resets the values of [Position] items to the factory
default settings.
Note
●
In some cases, noise appears outside the area
picture is displayed, but it is not a malfunction.
●
It is only available for PC input.
●
In the case that [Auto setup] cannot work well, [Auto
setup] may work well to execute [Reset] before [Auto
setup].
No signal power off
When this function is set to [Enable], the power is turned
off (standby) automatically when there is no signal of the
display for 10 minutes.
Starting from 1 minute- before the turn off, the
remaining time will be displayed.
No signal 33 Sec.
No activity power off
When this function is set to [Enable], the power is turned
off (standby) automatically when there is no operation of
the Display for 4 hours.
Starting from 1 minute- before the turn off, the
remaining time will be displayed.
No activity power off 33 Sec.