Panasonic TH-55VF2HW - Digital ZOOM

English
38
Digital ZOOM
Select the screen areas (25 areas) to zoom in, and
zoom in the selected image areas ×2, ×3 or ×4.
(Use the remote control. The main unit’s buttons cannot
be used for operation.)
Enter
Digital Zoom
Select
Exit
Note
●
To use the digital zoom function, assign [Digital
zoom] to the numeric button of the remote control in
[Function button settings] - [Shortcut].
(see page 71)
1
Set the digital zoom mode.
Press the numeric button out of <0> to <9> that you
have assigned [Digital zoom].
●
Use the button you have set to [Digital zoom] in
[Function button settings] - [Shortcut].
×1
Exit
RETURN
ENTER
The screen aspect is set to [16:9], and the digital
zoom operation guide is displayed.
2
Select the image areas to zoom in.
Select pressing .
×1
Exit
RETURN
ENTER
Digital Zoom operation guide
3
Switch the zoom ratio for the screen
areas.
Switches every time <ENTER> is pressed.
×1 ×2 ×3 ×4
×1
Exit
×2
Exit
×3
Exit
×4
Exit
●
If no operation is performed for approx. 60
seconds when the zoom ratio for the screen is
“×1”, the unit exits the zoom mode.
●
If no operation is performed for approx. 3 seconds
when the zoom ratio for the screen is “×2”, “×3”
or “×4”, the digital zoom operation guide display
disappears. Pressing any of the
buttons displays the guide again.
4
Exit the digital zoom mode.
Press <RETURN> to exit the mode.
The screen returns to the previous state just before
entering the digital zoom mode, and the digital zoom
operation guide display disappears.
●
Press any of the following buttons to exit the
mode. Then, the operation of the pressed button
is performed.
Remote Control:
<AUTO SETUP> <POSITION> <PICTURE>
<INPUT> <SETUP> <SOUND> <DEFAULT>
<RECALL> <MUTE> <ASPECT> <OFF
TIMER> <FUNCTION GROUP> <MULTI
DISPLAY> <ECO> <VOL +> <VOL ->
<0> - <9>
Unit:
<INPUT (Unit)> <MENU (Unit)> <+ (Unit)>
<- (Unit)>
<ENTER (Unit)>
●
When the screen saver timer starts up, the digital
zoom mode finishes.
●
When the power is turned OFF, a force-quit is
performed.
•
When the power is turned OFF by pressing
<STANDBY> or <Power button (Unit)>
•
When the power is turned OFF by the off-timer
•
When the power is turned OFF by [No signal
power off] or [Power management].
Note
●
In the following cases, the digital zoom mode is not
available.
•
When [Multi display setting] is [On]
•
When the screen saver is in operation
•
When USB input is selected.
●
The zoomed image is rougher than the original
image.
●
For multi display use, use the functions in [Multi
display settings]. (see page 56)