Panasonic TH-55VF2HW - Screensaver (for Preventing Image Retention)

63
English
Note
●
While the menu is deleted, this setting will finish in
60 minutes after no operation, regardless of the
[Menu display duration] (see page 74) setting.
Remote control operation while the menu is deleted
Selecting colour
Adjusting red,
green and blue
Displayed for 5 seconds if remote control operation is
performed.
2048
0
0
Select colour
Red
[Select colour]
Select the colour to correct with
.
Adjusting red, green and blue
Adjust with numeric buttons (<1> to <9>).
Red
<1>‒
<2> Press and hold to reset to default.
<3> +
Green
<4>‒
<5> Press and hold to reset to default.
<6> +
Blue
<7>‒
<8> Press and hold to reset to default.
<9> +
●
Pressing and holding <1><4><7> and <3><6><9> will
increase or decrease the value in succession.
●
Pressing <2><5><8> briefly will show the current
value.
Note
●
While the menu is deleted, this setting cannot be
operated with the buttons on the unit.
Screensaver
(For preventing image retention)
Alleviates the occurrence of afterimage when displaying
still images or images with 4:3 aspect ratio for a long
time.
[Screensaver] - submenu screen
Screensaver
Start
10:00
Mode Off
TUESDAY 2019/01/01
■ Screensaver settings
Screensaver operation
When the Screensaver is operating, the following 5
patterns are displayed full screen for 5 seconds each,
and it will be repeated.
Black→Darkgrey→Grey→Lightgrey→White→
Lightgrey→Grey→Darkgrey
To start Screensaver now
Select [On] in [Mode].
Select [Start] and press <ENTER>.
●
The menu screen will disappear and the
Screensaver will be activated.
Screensaver
Start
10:00
Mode On
TUESDAY 2019/01/01
Note
●
If the following buttons are pressed while the screen
saver is operating, the screen saver is cancelled.
Remote control: <RETURN>
Main unit: <MENU (Unit)> <INPUT> <+ (Unit)>
<- (Unit)>
<ENTER (Unit)>
●
When the display is turned off, the Screensaver will
be deactivated.
To set interval of Screensaver
Select [Interval] in [Mode].
Set [Periodic time].
●
Press
to change the time by 15 minutes.
●
In [ENGLISH(US)] OSD language, [Periodic time]
is displayed as [SHOW DURATION].
Set [Operating time].
●
Press
once to change the time by 1 minute.
Keep pressing down to change the time by 15
minutes.
●
In [ENGLISH(US)] OSD language, [Operating
time] is displayed as [SAVER DURATION].