English
92
■ Detail control page
The detailed functions of the unit can be performed.
Click [Display control], then [Advanced control] to display
the Detail control page.
Enter a command. Use the same command used for
the serial control.
Response from the unit is displayed.
Command is sent and run.
Note
●
After the settings are changed, it may take a while till
the display status is displayed.
■ Detailed set up
When connecting by logging in with administer
privileges, you can make detailed settings for network
related to display.
■ LAN settings page
1
Click [Detailed set up] in the menu.
2
Click [Next].
The settings window appears, showing the current
settings.
•
To change the LAN settings, click [Change].
•
To return to the previous window, click [Back].
3
Complete the detailed settings and
click [Next].
Setting contents here are the same as the address
information contents set for the [LAN setup] menu of
the Display.
After all required items have been entered, click
[Next]. Then, a confirmation window appears.
4
Click [Submit].
The settings will be registered.
Note
●
Changing the setting of LAN while connected with
LAN might disconnect the connection.
■ Adjust clock page
Sets the clock-related items of this unit.
Click [Detailed set up], then [Adjust clock] to display the
Adjust clock page.
New date field
New time field
Button to update time and date settings
Note
●
Date and time is displayed as [- -] when they are not
set.
●
When [Network control] is set to [On] and it is in
standby mode, date and time display will be blank
and they cannot be set.
●
If the time becomes incorrect immediately after
setting the correct time, contact the dealer where you
bought the Display.
To Next Page
Loading...
