Panasonic TH-86SQ1W - Page 60

60
English
When PC is selected
59.95 Hz
154.00 MHz
1920x1200/60
74.04 kHz
0
Signal
Input resolution
V-freq.
H-freq.
Dot clock freq.
Input level
Signal format
Auto
MPEG noise reduction
Noise reduction
Off
Auto
Dynamic backlight control
Off
Frame creation
Off
Sync Auto
Cinema reality Off
Component/RGB-in select RGB
When Screen Transfer is selected
Signal
Noise reduction
MPEG noise reduction
Auto
Off
When USB / MEMORY VIEWER is selected
Signal
Noise reduction
MPEG noise reduction
Auto
Off
Frame creation Off
Note
●
[Signal] setup menu displays a different setting
condition for each input signal.
●
Menu that cannot be adjusted is greyed out.
■ [Component/RGB-in select]
This menu is displayed at PC signal input.
Select to match the signals from the source
connected to PC IN terminal.
[Component]:
YP
BPR/YCBCR signals
[RGB]:
RGB signals
■ [YUV/RGB-in select]
This menu is displayed at HDMI 1, HDMI 2,
DisplayPort, DIGITAL LINK, DVI-D IN and SLOT
inputs.
Select to match the signals from the source
connected to each terminal.
[Auto]:
YUV/RGB setting is automatically switched.
[YUV]:
YUV signals
[RGB]:
RGB signals
Note
●
Set for each input terminal (HDMI 1, HDMI 2,
DisplayPort, DIGITAL LINK, DVI-D IN, SLOT).
●
With DIGITAL LINK input, it is possible to set to
[YUV] and [RGB] only. It cannot be set to [Auto].
■ [Sync]
This menu is displayed at PC IN input.
Setting RGB/PC sync signal
[Auto]:
The H and V sync or synchronized signal is
automatically selected.
[on G]:
Uses a synchronized signal on the Video G
signal, which is input from the G connector.
[HV sync]:
Uses a synchronized signal on the Video HD/VD
signal, which is input from the HD/VD connector.
Setting Component sync signal
[Auto]:
The H and V sync or synchronized signal is
automatically selected.
[on Y]:
Uses a synchronized signal on the Video Y
signal, which is input from the Y connector.
[HV sync]:
Uses a synchronized signal on the Video HD/VD
signal, which is input from the HD/VD connector.
■ [Cinema reality]
Faithfully reproduces videos shot with cinema films.
Set this to [Off] normally.
Note
●
In [ENGLISH(US)] OSD language, [Cinema reality]
is displayed as [3:2 PULLDOWN].
●
If [Cinema reality] is set to [On], videos including
movies shot at 24 frames per second are
reproduced more naturally.
●
If the video is unnatural with [On] set, set it to [Off].
■ [Noise reduction]
Reduces picture noise.
[Off]:
Disables [Noise reduction].
[Min], [Mid], [Max]:
Sets strength of [Noise reduction].
[Auto]:
[Noise reduction] will be automatically selected
from [Min], [Mid] or [Max].
■ [MPEG noise reduction]
Reduces block noise and mosquito noise on MPEG
videos.
[Off]:
Disables [MPEG noise reduction].
[Min], [Mid], [Max]:
Sets strength of [MPEG noise reduction].