59
Hard Disk Drive
To change your hard disk drive, contact Panasonic Technical Support.
CAUTION
z Back up all the important data before removing the hard disk drive.
z If you need to read the hard disk data on another computer for repair or any other purpose, set [Hard Disk Lock] to
[Disable] in the [Security] menu of the Setup Utility
(Î page 64) before removing the hard disk drive.
z Carefully remove/insert the hard disk drive since the hard disk drive is extremely sensitive to shock. Note that static
electricity may affect some internal components.
1 Turn off the computer and disconnect the AC adaptor.
z Do not use standby or hibernation.
2 Remove the battery pack (Î page 16).
3 Insert/Remove the hard disk drive.
z To remove
Slide and hold the latch (A), and slide and lift the cover (B) carefully.
The hard disk drive is attached behind the cover.
Slide the cover back.
z To insert
Insert the hard disk drive until it clicks.
4 Insert the battery pack (Î page 16).
CAUTION
z Confirm that the latch is surely locked so that the hard disk drive does not fall when you carry the computer.
NOTE
z You can erase the data before changing the hard disk drive. (
⇒ Operating Instructions “Hard Disk Data Erase Utility”)
z You can check that the hard disk is recognized or not in the [Information] menu of the Setup Utility (Î page 61). If the
hard disk is not recognized, turn off the computer and insert it again.
Inserting/Removing the Hard Disk Drive
To Next Page
Loading...
