■ DVB, Analogue
1. Select Auto Setup and press OK to access.
2. Set DVB-C Auto Setup Settings and press OK to store. (DVB-C)
●
Scan Mode
Quick:
Scans the suitable frequency in your country.
Full:
Scans the whole frequency range.
●
Normally set Frequency, Symbol Rate and Network ID to Auto. If Auto
is not displayed or if necessary, enter each value specified by your
cable provider with Numeric buttons.
●
After settings, select Start scan and press OK to search.
3. A confirmation screen is displayed and press OK to apply your changes.
(Settings are made automatically.)
●
When the operation is completed, the channel at the lowest position will
be displayed.
■ Freeview
1. Select Auto Setup and press OK to access.
2. A confirmation screen is displayed and press OK to apply your changes.
(Settings are made automatically.)
●
When the operation is completed, the channel at the lowest position will
be displayed.
- 144 -
To Next Page
Loading...
