- 76 -
■ Analogue
Set Analogue channel manually after Auto Setup.
1. Select the channel position with numeric buttons
2. Select the channel with Channel Up / Down button
3. Search with /
4. Select Store with / and press OK to set
●
Use Fine Tuning to make small adjustments to the tuning of an individual
programme (affected by weather conditions, etc.).
●
If a VCR is connected only with the RF cable, select channel position 0.
Update Channel List
By updating the DVB channel list, you can add new channels, delete removed
channels or change channel names and positions automatically.
●
The channel list is updated while keeping your settings in Favourites Edit,
Channel List, Child Lock, etc.
●
Depending on the signal condition, the update may not work properly.
●
To update DVB-S channels, set Satellite, Search Mode and Scan Mode
before updating.
1) Select Satellite / Search Mode / Scan Mode with
/ and press OK
to access
2) Set each item with
/ and press OK to store
3) After settings, select Start scan with
/ and press OK to search
To Next Page
Loading...
