Assembling the Electronic Board
10
12
Remove the roller and paper.
Bend and remove the roller (➊), then remove
the paper with tape (➋). (The roller and paper
are needed for repacking.)
13
Attach the upper frame cover.
1) Align the upper frame cover with the metal
fittings on the left and right ends, then rotate it
in the direction of the arrows.
2) Be sure the back of the frame cover (A) is fit to
the frame of the screen unit and push down
the two rivets.
3) Place the wrench in the wrench holder.
1
2
2
Metal fitting
A
Wrench
UB-5325_IM_EN.book 10 ページ ２００８年１月８日 火曜日 午後５時７分
To Next Page
Loading...
