With other products
With a printer (PictBridge) (VDR-D150 only)
96
LSQT1048
8 Select the layout setting on [ PAGE LAYOUT].
≥ You cannot set page layouts not supported on the printer.
9 Select [ PRINT] # [YES] and press the joystick.
The pictures are printed.
≥ Exit PictBridge by disconnecting the USB cable after the pictures have
been printed.
When you stop printing halfway
Move the joystick down.
A confirmation message appears. If [YES] is selected, the number of prints set is cancelled and the
screen returns to step 3. If [NO] is selected, all the settings are kept and the screen returns to
step 3.
≥ Avoid the following operations during printing.
These operations disable proper printing.
– Disconnecting the USB cable
– Removing the SD card
– Switching the mode dial
– Turning off the power
≥ Check the settings for the paper size, quality of
print, etc. on the printer.
≥ You cannot print pictures that cannot be played on
this unit.
≥ When the unit is connected directly to the printer,
the DPOF settings cannot be used.
≥ Connect the printer directly to this unit. Do not use a
USB hub.
STANDARD: Layout specific to the printer
: No frame print
: Frame print
LSQT1048(ENG).book 96 ページ ２００６年２月６日 月曜日 午後２時１３分
To Next Page
Loading...
