Panasonic VDR-D150EB - Page 99

11.Removal of Side R/SD Ass'y
1) Close the LCD (Ass'y).
2) Remove the 2 Screws (408, 457) as shown below.
Installation of Side R/SD Ass'y
1) Pass the LCD F.P.C. into the slot.
2) Install the LCD (Ass'y) into the Side R/SD Ass'y so as
not to damage the LCD open/close SW.
LCD (Ass'y)
LCD F.P.C.
Side R/SD Ass'y
LCD
open/close
SW.
408
457
slot
Fig. D11-1
Removal of Speaker, Side R P.C.B. and Open Switch
P.C.B.
1) Remove the 2 Screws (533) and remove the Speaker
Spring Plate.
2) Disconnect Connector P6301, then remove the
Speaker.
3) Remove the 2 Screws (533), then unsolder the connector
leads to remove the Side R P.C.B.
4) Remove Screw (533) and sheet, then remove the Open
Switch P.C.B.
P6301
Side R P.C.B.
Open
Switch
P.C.B.
sheet
Speaker
Speaker
Spring
Plate
tab
Solder
533
533
533
533
533
Fig. D11-2
12.Installation of LCD Backlight P.C.B., LCD Panel Ass'y,
LCD Shield Case Unit and LCD Case B
Be extremely careful of LEDs when handling the LCD
Backlight P.C.B.
Install in order shown below.
1) Install the LCD Shield Case Unit into the LCD Case B
with 2 bosses.
2) Install the LCD Panel Ass'y onto the LCD Case B with
the 7 Locking Tabs (L-3), (L-4) while carefully bending
the LCD F.P.C. at its base so as not to damage it.
3) Install the LCD Backlight P.C.B. onto the LCD Panel
Ass'y with the Locking Tab (L-2).
4) Tighten Screw (533) while keeping the LCD Backlight
P.C.B. pressed toward the right. Then, connect the
F.P.C. to Connector FP8102.
boss
boss
LCD
Shield
Case
Unit
LCD Panel Ass'y
LCD
F.P.C.
LCD Backlight P.C.B.
LCD Case B
(L-3)
(L-3)
(L-3)
(L-4)
(L-4)
(L-4)
(L-3)
(L-2)
LEDs
FP8102
Press
Bend
533
Fig. D12