38
Editing and Setting Channels
The current channel settings can be changed according to your needs and reception
conditions.
_ Display the menu
Select "Setup"
Select "ANT/Cable setup"
Select the function
• Press to exit from
a menu screen
EXIT
Set
_To reset the settings of the Setup menu
_ Select "Reset to defaults" in the Setup menu (@) and
press OK
_2_Input your 4-digit password with number buttons
Automatically searches and adds available channels to the memory.
Select "ANT in" _3_Select a scanning mode (p. 13)
,®Select "Cable" or "Antenna"
Or select "Not used" (p. 13).
_ Select "Auto program"
Settings are made automatically
® After the scanning is completed, select "Apply".
(see below _5_).
® All previously saved channels are erased.
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel list
manually.
You can select a channel tuning mode (Digital only/Analog
only) in "Channel surf mode"(p. 29)
_ Select "Edit"
Select the item to edit
Favorite
Caption Add
¼
R G
__Proceed to
nextpage
Go backtothe previous
page
® Caption:
Changes the station identifier
® Favorite:
Registers channels to the
Favorite List
® Add:
Adds or skips channels
Edit
® Caption
Select or edit the station identifier.
(maximum 7 characters available)
® Favorite
)select
RETURN
Lset favoriteJ Select the number
® Add RETURN
Press OK to select "Yes (add)" or "No (skip)" @
@ Move the cursor to a channel number
_Select "Apply"
channel
To cancel the Edit
Check the signal strength if interference is found or freezing occurs on a digital image.
BBD
DBD
BmB or
® Not available if "Cable" is selected in "ANT in" (see above).
® Available only for digital antenna channels.
® If "Lock" (p. 36) is activated and "ANT/Cable setup" is selected, "Enter password." will be displayed.
@
Fn
o_
5"
t.Q
Q.
03
(D
5"
t.C}
O
::3-
(D
39
To Next Page
Loading...
