First Time Setup
The first time setup screen
is
displayed only when the TV
is
turned on for the first time after the power cord
is
inserted into a wall outlet and when "Auto power on"
(p.
55)
is
set to "No".
••
-."
a.
_.
(1)-'
:::J~
ro+
_.
-l
-<'
_.
-·3
c5CD
aU>
os.
:::Jc
~"O
o
en
You are selecting the store
demonstrallon
mode
Yes
~
If
(OiJ
<;.(>Iect
Yes
"\e
picture
mode
N I
e;;ula
I,
reset
'0
Ii
va
and
a
FlclL.fl~'
Re'resn
messaqe
;VlI
CE'
j~r.:layec
en
the
sc'ee,
• Please confirm your selection (Home Use) before pressing OK button.
• If
you
select
"Store
Demonstration"
by
mistake
in
@,
confirmation
screen
will
be
displayed.
(@)GJselect
~~@OK
Turn the TV On with the POWER button
(TV)
(Remote)
POWER
@
Select
your
viewing
mode
(Be sure
to
select "Home use")
G0.:.K
..
)~G)select
~~@OK
it
Select "No" and return to previous screen @
• If you select "Yes", Screen enters the store demonstration mode.
To
display the "Set viewing mode" screen again as shown above and
select "Home Use", do one
of
the following:
• Press and hold down the front POWER button for at least five seconds.
• Unplug power cord for 30 seconds and plug it again.
® Select
your
country
~J;~I
POWER
~
or r
j
fl
~
Configure your viewing mode
~----
CD
Select
your
language
(
Note)
it
If you use any other step other than @ then turn the TV off, or if you used
the EXIT button to quit before completing the settings, the next time you turn
the TV
on,
"First time setup" will not be automatically displayed.
• The settings up to that point are saved.
•
You
can start "First time setup".
(p.
55)
..
Language, ANT/Cable setup, Input labels, and Clock can also
be
changed
in
the Settings Menu. (p. 55)
15
To Next Page
Loading...
