Disposal
3D
Eyewear
A lithium-ion polymer rechargeable battery is built
in
to the 3D Eyewear. Please discard according to local regulations.
When disposing this product, disassemble properly by following the procedure below, and remove the internal
rechargeable battery.
IDo
not
disassemble
this
product
except
when
disposing
of
it.
• Danger
• As the rechargeable battery is specifically for this product, do not use it for any other device.
o
Do
not charge the removed battery.
o
Do
not throw the battery
in
a fire, or apply heat to it.
o Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify
it.
o Do not let the wires touch any other metal or each other.
o
Do
not carry
or
store the battery with a necklace, hair pin, or the like.
o
Do
not charge, use, or leave the battery
in
a hot location such as near a fire or under the hot sun.
Doing
so
may cause the battery to generate heat, ignite, or rupture.
• Warning
• Do
not
place the removed battery, screws, and
other
items
within
reach
of
infants.
Accidental swallowing
of
such
an
item may have an adverse effect on the body.
o
In
the event that you think such
an
item has been swallowed, consult a doctor immediately.
• In
the
event
of
fluid
leaking
from
the
battery, take
the
following
measure, and
do
not
touch
the
fluid
with
bare
hands.
Fluid entering into an eye may cause loss of eyesight.
o Wash the eye with water immediately without rubbing it, and then consult a doctor.
Fluid getting
on
your body or clothes may cause inflammation of the skin or injury.
o Sufficiently rinse with clean water, and then consult a doctor.
•
How
to
remove the battery
Disassemble this product after the battery has run out
of
power.
The
following
figures
are intended
to
explain
how
to
dispose
of
the
product,
not
for
describing
how
to
repair.
The
product
cannot
be repaired
once
it
has been disassembled.
62
1.
Fold the part of the
frame without the power
switch, and then remove
the two screws on the
inside
of
the hinge with a
precision Phillips (plus + )
screwdriver.
2.
Bend the frame inwards
and pull it off from the side
cover.
o If it is difficult to remove,
insert a flat-blade (minus - )
screwdriver and force it off.
~
Frame
Side cover
\
3.
Remove the battery from
inside the side cover, and
cut the two wires one by one
with scissors.
o Insulate the wire parts
of
the removed battery with
cellophane tape.
(
Note)
• Take sufficient care when performing this work
so
as not
to injure yourself.
• Do not damage or dismantle the battery.
To Next Page
Loading...
