Accessories
3D Eyewear (1)
<;f
/
'~.
..
".
-,~
3D Eyewear case (1)
Charging cable (1)
Ferrite core (1)
~?<Z2
..-.0::.>
\~.-
Attaching Ferrite Core
Be sure to attach the provided ferrite core to the charging cable to reduce interference
or
electrical noise.
1.
Attach the ferrite core as close to USB connector
of
the charging cable as shown.
2.
Close the ferrite core until it clicks.
USB
connector
Charging the 3D Eyewear
•
<
roO
~
:::J
c.o
c..v
o
3
Q)
c.o
CD
(J)
o
:::J
~
1.
Turn off the television power, and set the 3D Eyewear power switch to "OFF".
2.
Connect as shown in the diagram, and turn on the television power.
• The indicator lamp lights red, and charging starts.
• When the indicator lamp turns off, charging is complete.
(Approximately
2 hours required)
3.
Turn off the television power, and remove the charging cable.
USB
connector
(
Note)
• Be sure to turn the television power on when charging.
The
battery will not be charged when the television power is
off.
25
To Next Page
Loading...
