Settings
«<Items
It~in
Descriptiott
t
'
• Some menus are grayed out depending on the input signal or condition.
(e.g. "Zoom adjustments" will
be
grayed out if the aspect
is
not set to Zoom.)
Aspect Screen format FULL/H-FILLI Changes the format (aspect ratio).
adjustments
JUST/4:3/Z00M
Lets you choose the aspect depending on the format of
received signal.
(p.
57)
HD
size
Size
lISize
2
Selects between 95 % (Size 1) or 100 % (Size 2) for the
scanning area with High-definition signal.
Select "Size
1"
if noise
is
generated on the edges of the screen.
• Size
1:
Selected item for "HD size". Scanning 95 %
• Size
2:
Selected item for "HD size". Scanning 100 %
H size
Size 1/Size 2
Adjusts
the
horizontal display range
to
reduce noise of
both
side
edges of
an
image.
Size
2:
Adjusts the image size according to the aspect mode to
reduce noise.
(p.
57)
Zoom
adjustments
Adjusts vertical alignment and size when aspect setting
is
"ZOOM".
PC
adjustments
Reset to defaults
Resets PC adjustments.
Sync
H & V
The
H
and
V
sync
signals
are
input
from
the
HDND
connector.
(p.
60)
On green Uses a synchronized signal on the Video G signal, which
is
input from the G connector.
(p.
60)
Dot clock
Alleviates
the
problem
if a
picture
appears
to
be
vertically-striped,
flickers
partially
or
is
blurred.
';'
,
Adjusts the vertical position.
Adjusts the horizontal position. :
0
I
-,
I
:0
H-position
V-position
Clock phase
Alleviates the problem if the whole picture appears to flicker
or
is
blurred.
First adjust the Dot Clock to get the best possible picture, then adjust the clock Phase
so that a clear picture appears.
•
It
may not be possible to display a clear picture due to poor input signals.
Input
resolution
Switches to wide display.
• VGA (640
x
480 pixels), WVGA (852
x
480 pixels), XGA
(1
,024
x
768 pixels),
WXGA
(1
,280
x
768 pixels)
• Options change depending on signals
H-frequency
V-frequency
Displays the H (Horizontal)N (Vertical) frequencies.
Display range
Horizontal:15 -
110kHz
Vertical: 48 - 120 Hz
HDMI settings
HDMI/DVI RGB
range (HDMI1-4)
Auto/
Prevents the blown out highlights and blocked up shadows when
Standard a wide-range signal
is
received. Selects between standard RGB
(16-235)/ range (16-235 bits) or non-compliance (0-255 bits).
Auto: Switches the RGB range (Standard (16-235)/
Nonstandard Nonstandard) depending on the HOMI signal information.
Auto: Switches content type automatically depending
on
the
HDMI signal information.
Photo: Best setting for JPEG viewing.
Graphics: Best setting for On-Screen display
of
connected
equipment.
Off/Auto/Photo/ Sets content type to each HOMI input.
Graphics
Contents type
(HDMI1-4)
52
To Next Page
Loading...
