Frequently Asked Questions ●
FAQs, etc.
69
Problem Actions
Screen
Chaotic image, noisy
Set “P-NR” in the Picture Menu (to remove noise). (p. 28)●
Check nearby electrical products●
(fluorescent lamp, DECT phones, mobile phones, microwave, etc.).
No image can be displayed
Is “Contrast”, “Brightness” or “Colour” in the Picture Menu set to the ●
minimum? (p. 28)
Please also refer to “Neither image nor sound is produced” (p. 68). ●
Blurry or distorted image
(no sound or low volume)
Reset channels. (p. 36 and p. 37)●
Please also refer to “Neither image nor sound is produced” (p. 68).●
Unusual image is displayed
Turn the TV Off with Mains power On / Off switch, then turn it On ●
again.
If the problem persists, perform “Shipping Condition” (p. 46).
●
Sound
No sound is produced
Is “Sound mute” active? (p. 8)●
Is the volume set to the minimum?●
Please also refer to “Neither image nor sound is produced” (p. 68).●
Sound level is low
or sound is distorted
Sound signal reception may be deteriorated.●
Set “NICAM” (p. 29) in the Sound Menu to “Off”. (Analogue only)●
Please also refer to “Neither image nor sound is produced” (p. 68).●
Digital Channel
No programmes shown on TV
Guide
Check the digital transmitter.●
Adjust the direction of the aerial to another transmitter installed ●
nearby.
Check the analogue broadcast.
●
If the image quality is poor, check the aerial and consult your local
dealer.
Cannot find a channel
you have previously watched
The channel may broadcast for part of the day.●
Check the channel in the TV Guide. (p. 18)●
Channel position numbers may be changed by broadcasters.●
Reset channels. (p. 36 and p. 37)●
To Next Page
Loading...
