1. Introduction
3
Graphical symbols for use on equipment and their descriptions
1. Alternating current (A.C.) 2. Direct current (D.C.) 3. Protective earth 4. Protective bonding earth 5. Functional
earth 6. For indoor use only 7. Class P equipment (equipment in which protection against electric shock relies on
Double Insulation or Reinforced Insulation) 8. "ON" (power) 9. "OFF" (power) 10. Stand-by (power) 11. "ON"/"OFF"
(power; push-push) 12. Caution, risk of electric shock
1.4 Symbols, expressions, and styles
The following symbols, expressions, and styles are used in this document.
123456
789101112
Item How it is expressed Example
Text displayed on the
product’s display
Text is displayed in a special
font, usually enclosed in
quotation marks
“Initial settings”
Icons displayed on the
product’s display
Black-and-white illustration of
icon is used
Buttons with printing on
them or near them
Button printing is displayed,
usually wrapped in thick
brackets
MN
MN
Soft keys Black-and-white illustration of
the corresponding soft key icon
is used
Navigator key (sub
monitor only)
Either referred to by name, or
with a black-and-white
illustration
R "Use the navigator key to select..."
R "Press to select..."
R "Select..."
Procedures Usually written in an abbreviated
style. The verb may be omitted.
Unless otherwise stated, all
procedures are for both the main
monitor, extension monitor, and
sub monitor.
Main monitor/extension monitor example
→ “Display” → →
“Brightness”
R Meaning:
Press the soft key under the displayed
soft key icon, press the soft keys
under the displayed and
soft key icons to select “Display”, press
the soft key under the displayed soft
key icon, and then press to select
“Brightness”.
Sub monitor example
MN → “BRIGHTNESS” → (OK) →
select the desired setting.
R Meaning:
Press the MN button, use the navigator
key to select “BRIGHTNESS” on the display,
and then press the navigator key (OK).
SW274_IIQG.book Page 3 Friday, September 15, 2017 6:34 PM
To Next Page
Loading...
