80
VL-SWD272BX/SWD272CX/SWD272CX1/SWD272AZ/VL-WD613CX/VL-WD613CX1
Note:
• Whenever pressing [OFF] key during checking, return to a input screen.
• After the checking is finished, remove the battery from the wireless monitor station.
n To end Test Mode:
Keep pressing [OFF] key until “TEST MODE screen” is disappeared.
(5) KEY check
[KEY CODE]
1. Press [MONITOR] key, then press [F1] key.
2. Press all keys one by one except [OFF] key.
3. Press [OFF] key at last.
4. Press [OFF] key again.
LCD: KEY CODE
Pressed key name appears.
“OK” appears.
(If you miss to press any key, “NG” will appear when
OFF key is pressed.)
(6) Charging current
check
[BATT CURRENT]
1. Press [MONITOR] key, then press [OK].
2. Put the wireless monitor on the charger and check the
value.
3. Press [ ] or [ ] to select “OK” or “NG”.
LCD: BATT CURRENT
AD value is normal if it is bigger than 0x14 (hex. Value).
*Check charging coil if it is smaller than 0x13.
In case of OK, press [].
In case of NG, press [].
No. Items Operations Points to be checked
To Next Page
Loading...
