68
VL-SWD272BX/SWD272CX/SWD272CX1/SWD272AZ/VL-WD613CX/VL-WD613CX1
10.3.2.1. Notice for Installing the coil
Note:
Check the value of charging current after attaching coil to the Main Board.
• Refer to Charging current check in After replacing Main board (for Wireless monitor station) (P.79).
1. Solder the coil which is packed with Main Board. Solder one end of
lead wire of coil from its outside to the upper side(+ side) position of
Microphone on the Main Board.
Attach the other end of lead wire of coil from its inside, to the lower
side(- side) Microphone on the Main Board.
Notice:
Before soldering to the coil wire, confirm the printed mark (right or left of
hole) at the backside of coil.
2. Place the P.C.B. with components side up, and bend the coil vertically.
3. Insert formed-coil into two slits of front cabinet of portable unit, in the
direction as indicated by arrow No.1. Then slide the entire Main Board
to the direction of arrow No.2 to install to the front cabinet.
To Next Page
Loading...
