212
WARNING
17. Disassembly and Assembly Instructions
High Voltage are generated in the electrical parts area by the capacitor. Ensure that the capacitor has discharged sufficiently before proceeding
with repair work. Failure to heed this caution may result in electric shocks.
17.1 To Remove Front Plate
Hook
Lift up
1. Remove the 2 mounting screws which located at bottom of the
front plate.
2. Gently pull the lower section of the front plate towards you to
remove the front plate from left and right hooks.
3. Hold the left edge and right edge of front plate to lift up fron
plate from hooks.
17.2 To Remove Pressure Gauge
1. Remove 2 screws.
2. Use spanner to release nut of pressure gauge
To Next Page
Loading...
