To Next PageTo Next PageWhy is my Panasonic Heat Pump system hard to heat up?
Your Panasonic Heat Pump system may take longer to heat up if the panel and floor are heated simultaneously, which can decrease the warm water temperature and reduce heating ability. Also, low outdoor air temperature or a low preset water outlet temperature can extend the heating time. Check if the discharge outlet or intake inlet in the outdoor unit is blocked by obstacles like snow.
Why does my Panasonic WH-SXC12H9E8 Heat Pump system not heat up instantly?
If the system starts operating at a cold water temperature, it will take some time to heat up the water.
Why does steam come out of the outdoor Panasonic WH-SXC12H9E8 Heat Pump unit in heating mode?
The steam is a result of the defrost operation in the heat exchanger.
Why does my Panasonic WH-SXC12H9E8 backup heater automatically turn on when it is disabled?
The backup heater may turn on automatically due to the protection control of the indoor unit heat exchanger.
Why does my Panasonic Heat Pump outdoor unit emit water or steam?
The emission of water or steam from the outdoor unit is due to condensation or evaporation occurring in the pipes.
Why does the Panasonic WH-SXC12H9E8 Heat Pump make a loud refrigerant noise for several minutes?
The loud refrigerant noise is caused by protection control during deice operation when the outdoor ambient temperature is lower than -10 °C.
What causes the water flowing sound during Panasonic WH-SXC12H9E8 Heat Pump operation?
The water flowing sound is due to refrigerant flow inside the unit.
Why does my Panasonic WH-SXC12H9E8 outdoor unit not operate?
The outdoor unit may not operate due to the system's protection control when the outdoor temperature is outside of the operating range.
Why does my Panasonic WH-SXC12H9E8 Heat Pump operation start automatically when the timer is not set?
The operation may start automatically because the sterilization timer has been set.
Why is the Panasonic WH-SXC12H9E8 Heat Pump COOL mode unavailable?
COOL mode is unavailable because the system has locked to operate in HEAT mode only.
General| Heating Capacity | 12.00 kW |
|---|---|
| Energy Class Heating | A++ |
| Refrigerant | R32 |
| Weight (Indoor Unit) | 45 kg |
| Series | Aquarea |
| Cooling Capacity | 10 kW |
| Energy Efficiency Ratio (Heating) | 4.67 |
| Noise Level (Indoor Unit) | 30 dB(A) |
| Noise Level (Outdoor Unit) | 56 dB(A) |
| Operating Temperature Range (Heating) | -20°C to +35°C |
| Operating Temperature Range (Cooling) | -10°C to +43°C |
| Type | Air-to-Water Heat Pump |
