84
12.4 Appendix
12.4.1 Variation of system
This section introduces variation of various systems using Air-To-Water Heatpump and actual setting method.
12.4.1.1 Introduce application related to temperature setting
12.4.1.1.1 Temperature setting variation for heating
1. Remote Controller
Indoor
Outdoor
System setup
Water temperature
Floor heating
Setting of remote controller
Installer setting
Optional PCB connectivity - No
Zone & Sensor:
Connect floor heating or radiator directly to the Tank Unit.
Remote controller is installed on Tank Unit.
This is the basic form of the most simple system.
2. Room Thermostat
Outdoor
Indoor
Installer setting
System setup
Room thermostat
Internal
Tank Unit receive Room Thermo signal (ON/OFF) from Remote controller
to control HP and circulation pump.
There is a build-in thermistor in the remote controller.
Floor heating
Setting of remote controller
Optional PCB connectivity - No
Zone & Sensor:
Connect floor heating or radiator directly to the Tank Unit.
Remove remote controller from Tank Unit and install it in the room where floor heating is installed.
This is an application that uses remote controller as Room Thermostat.
To Next Page
Loading...
