Panasonic Whisper Green Select FV-0511VKS3S - Installation (Wall Mounting)

Bend down 4 tabs and align bracket to the stud.
Align and install bracket to stud by using
2-preinstalled tapping screws.
Extend bracket to the other stud.
Install bracket to stud by using
2-preinstalled tapping screws.
The Flex-Z Fast bracket position can be adjusted from 16" to 24" between studs.
Install Flex-Z Fast bracket
Remove junction box cover
and secure conduit or stress
relief to junction box knock-out hole.
Install the circular exhaust duct
and secure it with clamps or ties
and seal it with mastic or approved
foil tape. A 4 or 6 inch circular
duct is needed to connect to
the relevant part of the adapter.
Install the adapter to Flex-Z Fast bracket
by using 2 self-drilling screws.
Install circular exhaust duct
Complete the wiring; please refer to
step 4 on page 12.
Bend down 4 tabs
2 Tapping screws
(ST4.2X20)
Flex-Z Fast ® bracket
Align
2 Tapping screws
(ST4.2X20)
Extend
Knock-out
hole
Mastic or
approved
foil tape
Circular exhaust
duct
Junction Box
cover
Conduit
2 Self-drilling
screws
Stud
Stud
1. The adapter of product must
be installed upward.
Guide Parts
Hook
Plug connector
Guide Parts
Hook
Insert and secure fan body
2 Self-drilling screw
Flange
CAUTION
INSTALLATION (WALL MOUNTING)
15
Machine screw (M4X8)
Receptacle